Canister Purge Solenoid: Service and Repair

Purge Control Solenoid Valve

REMOVAL

1. PURGE CONTROL SOLENOID VALVE 1

1. Remove the collector cover.
2. Disconnect the ground cable from battery.






3. Remove the bolts which install purge control solenoid valve 1 to the intake manifold, and disconnect the connector from the purge control solenoid valve 1.






4. Disconnect the evaporation hose from the intake manifold and fuel pipe assembly.

2. PURGE CONTROL SOLENOID VALVE 2

1. Remove the collector cover.
2. Disconnect the ground cable from battery.






3. Disconnect the connector from purge control solenoid valve 2.






4. Disconnect the connector from purge control solenoid valve 2.
5. Disconnect the evaporation hose from the intake duct and fuel pipe assembly.
6. Remove the purge control solenoid valve 2 from the solenoid valve bracket assembly.






INSTALLATION

1. PURGE CONTROL SOLENOID VALVE 1
Install in the reverse order of removal.

NOTE: Connect the evaporation hose as shown in the figure.









2. PURGE CONTROL SOLENOID VALVE 2
Install in the reverse order of removal.

NOTE: Connect the evaporation hose as shown in the figure.