Rear Seat Belt

Rear Seat Belt

REMOVAL

1. OUTER SEAT BELT RH ASSEMBLY AND LH ASSEMBLY (SEDAN MODEL)
1. Remove the rear seat cushion and backrest shoulder.
2. Remove the seat belt lower anchor bolt.






3. Remove the rear quarter trim.
4. Remove the bolts, and then detach the outer seat belt assembly.






2. SHOULDER SEAT BELT CENTER ASSEMBLY (SEDAN MODEL)
1. Remove the rear seat cushion and backrest shoulder.
2. Remove the rear quarter trim.
3. Remove the rear shelf trim.
4. Remove the bolts, then remove the shoulder seat belt assembly.






3. CENTER SEAT BELT RH ASSEMBLY AND LH ASSEMBLY (SEDAN MODEL)
1. Remove the rear seat cushion.
2. Remove the bolts, then remove the center seat belt LH assembly.






4. OUTER SEAT BELT RH ASSEMBLY AND LH ASSEMBLY (WAGON MODEL)
1. Remove the luggage floor box.
2. Remove the rear seat cushion and backrest shoulder.
3. Remove the rear quarter lower trim.
4. Remove the bolt to remove outer seat belt retractor.






5. Remove the bolt to remove the outer seat belt guide.






5. SHOULDER SEAT BELT CENTER ASSEMBLY (WAGON MODEL)
1. Remove the quarter rear pillar trim.
2. Remove the cover (A) from roof trim, and then insert it to the inside of roof trim.






3. Remove the clips, and then lower the roof trim end.

CAUTION: When removing the roof trim clip, do not pull the roof trim end backward with excessive force. There is the possibility of the roof trim being damaged.






4. Remove the bolt to remove the seat belt retractor.






6. CENTER SEAT BELT RH ASSEMBLY AND LH ASSEMBLY (WAGON MODEL)
1. Remove the rear seat cushion.
2. Remove the bolts, then remove the center seat belt assembly.






INSTALLATION

CAUTION:
- During installation, make sure that the seat belts are not twisted.
- During installation, make sure that the center seat belt assembly (RH & LH) are properly pulled out from the slit of seat cushions.
- After installation, make sure that the seat belts are smoothly extended and wound.
- If the vehicle is equipped with rear outer seat belts (wagon model), make sure that the seat belts are wound after installing the seat belt guide.






Install in the reverse order of removal.