Glove Compartment: Service and Repair

GLOVE BOX

REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the console box.
3. Remove the console front panel.







NOTE:
- For the AT model, remove the ring indicator.
- For the MT model, remove the shift knob.

4. Remove the console side garnish.







5. Remove the front inside scuff plate (A) and front pillar lower trim (B). [Ref. to REMOVAL, Lower Inner Trim.]







6. Remove the clips, and remove the glove box lower cover.







7. Remove the console side panel.







8. Remove the instrument panel side cover, and remove the clip.







9. Remove the strap of the glove box damper.
10. Remove the backside of stopper on one side, and remove the glove box lid.







11. Remove the harness holder and connector holder.







12. Remove the screws and upper clip to remove the glove box.







INSTALLATION

Install in the reverse order of removal.