6MT
REPLACEMENT1. Clean the transmission exterior.
2. Drain transmission gear oil completely.
3. Remove the rear exhaust pipe and muffler.
4. Remove the heat shield cover. (If equipped)
5. Remove the propeller shaft.
6. Remove the oil seal using ST.
ST 398527700 PULLER ASSY
7. Using the ST, install the oil seal.
ST 498057300 INSTALLER
8. Install the propeller shaft.
9. Install the heat shield cover. (If equipped)
10. Install the rear exhaust pipe and muffler.
11. Pour in the transmission gear oil and check the oil level.