Fuel Sub Level Sensor

Fuel Sub Level Sensor

REMOVAL

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:
- Be careful not to spill fuel.
- When the fuel meter indication is higher than two third of the total, perform the work after draining the fuel not to spill the fuel.

1. Drain fuel.
2. Remove the rear seat.
3. Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.






4. Disconnect the connector from the fuel sub level sensor.






5. Disconnect the quick connector, and then disconnect the fuel delivery hose and jet pump hose.
6. Remove the nuts and bolts which install fuel sub level sensor on fuel tank.






7. Remove the fuel sub level sensor.

INSTALLATION
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align the protrusion (A) of gasket with the position shown in the figure.
- Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
- Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

NOTE: Use a new gasket and retainer.