DTC - General Description

DTC P0345 CAMSHAFT POSITION SENSOR "A" CIRCUIT (BANK 2)

1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of the camshaft position sensor.
Judge as NG when the number of camshaft signals remains abnormal.

2. COMPONENT DESCRIPTION









3. ENABLE CONDITION






4. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.

5. DIAGNOSTIC METHOD

- Abnormality Judgment 1
Judge as NG when the condition where the number of camshaft position sensor signals are less than 3 times during 2 engine speed. continues.






Time Needed for Diagnosis: Two engine revolutions x 4 time
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

- Normality Judgement 1
Judge as OK and clear the NG when the malfunction criteria below are met.






Time Needed for Diagnosis: Two engine revolutions

- Abnormality Judgment 2
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.






Time Needed for Diagnosis: 3000 ms

- Normality Judgement 2
Judge as OK and clear the NG if the continuous time while the following conditions are established is more than the predetermined time.






Time Needed for Diagnosis: Less than 1 second

6. DTC CLEAR CONDITION
- When the OK idling cycle is completed 40 times in a row
- When "Clear Memory" is performed

7. MALFUNCTION INDICATOR LIGHT CLEAR CONDITIONS
- When the OK driving cycle is completed 3 times in a row
- When "Clear Memory" is performed

8. FAIL SAFE
- Ignition timing whole learning compensation:
- Enter the initial value (whole learning compensation factor = 0.5, Variable amount of whole learning compensation factor = 0.25) to the whole learning compensation factor and variable amount of whole learning compensation factor when IG OFF, and then make the whole learning incomplete.
- Enter the initial value (whole learning compensation factor = 0.5, Variable amount of whole learning compensation factor = 0.25) to the whole learning compensation factor and variable amount of whole learning compensation factor when making a normality judgment from abnormality judgment, and then make the whole learning incomplete.
- Ignition timing partial learning compensation:
- Enter the initial value (0° CA) to the compensation value of partial learning zone with IG OFF.
- Enter the initial value (0° CA) to the compensation value of the partial learning zone when making a normality judgment -> abnormality judgment.
- AVCS control: Maximum timing retard learning is not complete or maximum timing retard learning completion is not experienced.
- ISC feedback compensation: Do not perform the AVCS actual timing advance compensation. Make the OCV driving Duty to be the given value (9.36%).

9. ECM OPERATION AT DTC SETTING
Memorize the freeze frame data. (For test mode $02)