Warning Light Illumination Pattern
Warning Light Illumination PatternINSPECTION
1) When warning lights or indicator lights do not illuminate in accordance with this illumination pattern, there must be an electrical malfunction.
2) When warning lights or indicator lights remain constantly OFF, check the combination meter circuit or CAN communication circuit.
3) When the ABS warning light and the hill start assist warning light do not go off, check the combination meter circuit.
4) When the VDC operation indicator light, VDC warning light and VDC multi mode indicator light do not turn off, check the combination meter circuit or CAN communication circuit.
NOTE:
^ Even though the ABS warning light does not go off after 2 seconds from ABS warning light illumination, the ABS system operates normally when the warning light goes off while driving at approximately 12 km/h (7 MPH). However, the ABS system does not work while the ABS warning light is illuminated.
^ It may take several minutes before VDC warning light and VDC multi mode indicator light turns off if the vehicle is parked under low temperatures for some time. This is not defective because it is resulted from low engine coolant temperature.
^ With the vehicle jack stands/lifted or set on free rollers, when the wheels lock or spin after starting the engine, the ABS warning light, VDC warning light and VDC multi mode indicator light may illuminate because VDCCM & H/U detects an abnormal condition from the ABS wheel speed sensors. In this case, this is not a malfunction. Perform the Clear Memory Mode.
5) If the VDC warning light and VDC multi mode indicator light illumination pattern when the VDC mode change switch is operated do not match the following, check the VDC mode change switch circuit, CAN communication circuit or combination meter circuit.
