Rear Seat
REAR SEATRear Seat:
REMOVAL
CAUTION:
- Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Read the cautions given in AB section before removing the rear seat.
- The airbag system is fitted with a backup power source. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 20 seconds before starting the service of airbag system.
1. Remove the three hooks while lifting up the rear seat cushion.
2. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.
3. Remove the headrest, and then tilt the backrest forward.
4. Remove the luggage floor mat.
5. Turn over the seat cover to remove the bolt.
6. Remove the backrest from hinge assembly LH (hinge assembly RH).
NOTE: The backrest cannot be detached while the hinge assembly side and the backrest pin are not aligned.
INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Description".