Differential Side Retainer Oil Seal
Differential Side Retainer Oil SealREPLACEMENT
1) Lift the vehicle.
2) Remove the front exhaust pipe and center exhaust pipe.
3) Drain the gear oil from the drain plug.
CAUTION:
^ Immediately after the vehicle has been running or after idling for a long time, the differential gear oil will be hot. Be careful not to burn yourself.
^ Be careful not to spill the differential gear oil on exhaust pipe to prevent it from emitting smoke or causing fires. If differential gear oil is spilled on the exhaust pipe, wipe it off completely.
4) Tighten the drain plug.
NOTE: Use a new gasket.
Tightening torque:
Oil pan side
44 Nm (4.5 kgf-m, 32.5 ft-lb)
Clutch housing side
70 Nm (7.1 kgf-m, 51.6 ft-lb)
5) Separate the front drive shaft from the transmission.
6) Remove the differential side retainer oil seal by using a flat tip screwdriver or similar tools.
7) Using the ST, install the differential side retainer oil seal by lightly tapping with a hammer.
ST 18675AA000 DIFFERENTIAL SIDE OIL SEAL INSTALLER
8) Apply gear oil to the oil seal lips.
9) Set the ST to the side retainer.
ST 28399SA010 OIL SEAL PROTECTOR
10) Install the front drive shaft into the transmission.
NOTE: Replace the circlip of drive shaft with a new part.
11) Install the front drive shaft into transmission, remove the ST and insert the drive shaft securely.
ST 28399SA010 OIL SEAL PROTECTOR
12) Install the front exhaust pipe and the center exhaust pipe.
13) Lower the vehicle.
14) Pour gear oil through the oil level gauge hole.
Recommended gear oil:
GL-5 (75W-90) or equivalent
Gear oil capacity:
4.1 l (4.3 US qt, 3.6 Imp qt)
15) Check the level of the gear oil.