Real-Time Diagnosis

REAL-TIME DIAGNOSIS
1. Connect the select monitor.
2. Turn the ignition switch and cruise control main switch to ON.
3. Turn the Subaru Select Monitor power switch to ON.
4. On the Main Menu display screen, select the {2. Each System Check} and press [YES] key.
5. On the System Selection display screen, select the {Engine} and press [YES] key.
6. Press the [YES] key after the information of engine type has been displayed.
7. On the Cruise Control Diagnosis display screen, select the {Current Data Display & Save} and press [YES] key.
8. Make sure that normal indication is displayed when operated as indicated below:
- Depress/release the brake pedal. (Stop light switch and brake switch turn ON.)
- Turn ON the "SET/COAST" switch.
- Turn ON the "RES/ACC" switch.
- Turn ON the "CANCEL" switch. (The "SET/ COAST" and "RES/ACC" switch are turned ON at same time.)
- Depress/release the clutch pedal. (MT model)
- Set the shift lever to any position other than neutral. (MT model)
- Place the select lever in any position other than "P" or "N". (AT model)

NOTE:
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION.
- For details concerning DTCs, refer to the List of DTC. Cruise Control - Diagnostics