Gear Sensor/Switch: Service and Repair

Switches and Harness

REMOVAL

BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1. Disconnect the ground cable from battery.
2. Remove the air intake chamber and cleaner case. (Non-turbo model)
3. Remove the intercooler. (Turbo model)
4. Disconnect the connectors of back-up light switch and neutral position switch.





^ Non-turbo model





^ Turbo model
5. Lift-up the vehicle.





6. Remove the back-up light switch and neutral position switch with harness.

INSTALLATION

BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH





1. Install the back-up light switch and neutral position switch with harness.
Tightening torque: 32.3 Nm (3.3 kgf-cm, 23.8 ft. lbs.)
2. Connect the connectors of back-up light switch and neutral position switch.
3. Install the air intake chamber and cleaner case.
(Non-turbo model)
4. Install the intercooler. (Turbo model)
5. Connect the battery ground cable to battery.

INSPECTION

BACK-UP LIGHT SWITCH
Inspect the back-up light switch.

NEUTRAL POSITION SWITCH
1. Turn the ignition switch to OFF.
2. Disconnect the connector of neutral position switch.
3. Measure the resistance between neutral position switch terminals.





^ Non-turbo model





^ Turbo model
4. Replace the faulty parts.