Torque Sequence

1. Remove oil on the mating surface of bearing and cylinder block before installation. Apply a coat of engine oil to crankshaft pins.
2. Position the crankshaft on the #2 and #4 cylinder block.





3. Apply liquid gasket to the mating surface of #1 and #3 cylinder block, and position it on #2 and #4 cylinder block.
Liquid gasket: THREE BOND 1215 (Part No. 004403007) or equivalent

NOTE: Do not allow liquid gasket to run over to O-ring grooves, oil passages, bearing grooves, etc.

4. Apply a coat of engine oil to washers and bolt threads.





5. Tighten the 10 mm cylinder block connecting bolts on LH side (A-D) in alphabetical sequence.





6. Tighten the 10 mm cylinder block connecting bolts on RH side (E-J) in alphabetical sequence.





7. Further tighten the LH side bolts (A-D) in alphabetical sequence.





8. Further tighten the RH side bolts (E-J) in alphabetical sequence.





9. Further tighten the LH side bolts (A-D) in alphabetical sequence.





10. Further tighten the RH side bolts (E-J) to 90° in alphabetical sequence.





11. Tighten the 8 mm and 6 mm cylinder block connecting bolts on LH side (A-H) in alphabetical sequence.