Fuel Pump: Service and Repair

Fuel Tank (Part 1):

Fuel Tank (Part 2):

Fuel Pump

REMOVAL

WARNING:
- PLACE "NO FIRE" SIGNS NEAR THE WORKING AREA.
- BE CAREFUL NOT TO SPILL FUEL.

NOTE: Fuel pump assembly consists of fuel pump and fuel level sensor.

1. Release the fuel pressure.
2. Drain fuel.
3. Remove the rear seat.




4. Remove the service hole cover.




5. Disconnect the connector from fuel pump.
6. Disconnect the quick connector, then disconnect the fuel delivery hose and jet pump hose.




7. Remove the nuts which install fuel pump assembly onto fuel tank.
8. Remove the fuel pump assembly from the fuel tank.

INSTALLATION




Install in the reverse order of removal.

NOTE:
- Use a new gasket.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- When assembling, point the protrusion of the gasket (A) towards the front of the vehicle.
- Insert the protrusion (B) of the gasket into the upper plate. (3 locations)
- Align the protrusion (C) of the fuel pump assembly to the cut out in the upper plate.
- Tighten the nuts to the specified torque in the order as shown in the figure.