General Scan Tool

General Scan Tool

OPERATION

1. HOW TO USE GENERAL SCAN TOOL
1. Prepare a general scan tool required by SAE J1978.




2. Open the cover and connect the general scan tool to data link connector located in the lower portion of instrument panel (on the driver's side).
3. Using the general scan tool, call up DTC and freeze frame data.
General scan tool functions consist of:
1. MODE $01: Current powertrain diagnostic data
2. MODE $02: Powertrain freeze frame data
3. MODE $03: Emission-related powertrain DTC
4. MODE $04: Clear/Reset emission-related diagnostic information
5. MODE $06: Request on-board monitoring test results for non-continuously monitored systems
6. MODE $07: Request on-board monitoring test results for continuously monitored systems
7. MODE $09: Request vehicle information Read out the data according to repair procedures. (For detailed operation procedures, refer to the operation manual of general scan tool.)

NOTE: For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". Basic Descriptions

2. MODE $01 (CURRENT POWERTRAIN DIAGNOSTIC DATA)
Refer to data denoting the current operating condition of analog input/output, digital input/output and/or the powertrain system.




A list of the support data and PID (Parameter Identification) codes are shown in the table.

3. MODE $02 (POWERTRAIN FREEZE FRAME DATA)




Refer to data denoting the operating condition when trouble is detected by the on-board diagnosis system. A list of the support data and PID (Parameter Identification) codes are shown in the table.

4. MODE $03 (EMISSION-RELATED POWERTRAIN DIAGNOSTIC TROUBLE CODE (DTC))
Refer to "List of Diagnostic Trouble Code (DTC)" for information about data denoting emission-related powertrain DTC. Basic Descriptions

5. MODE $04 (CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION)
Refer to the mode used to clear or reset emission-related diagnostic information (OBD-II trouble diagnostic information).

NOTE: Refer to general scan tool manufacturer's operation manual to clear or reset emission-related diagnostic information (MODE $04).

6. MODE $06




Refer to test value of troubleshooting and data of test limit on support data bit sequence table. List of support data is shown in the table.

7. MODE $07
Refer to the data of DTC (pending code) for troubleshooting result about emission in first time.

8. MODE $09
Refer to the data of vehicle specification (VIN, calibration ID, etc.).