Front Door Window Glass: Service and Repair

Front Door Glass

REMOVAL
1. Remove the front door trim.
2. Remove the sealing cover.
3. Remove the outer mirror assembly.




4. Remove the clip (A), and remove the front end of weather strip.




5. Remove the gusset.




6. Remove the stabilizer.




7. Remove the clips (A), and remove the rear end of weather strip.




8. Remove the screw (A) from the rear end of weather strip outer to remove weather strip outer.
9. Remove the screws to remove guide assembly.




10. Operate the power window switch to move glass to position shown in the figure, and then remove the two nuts through service holes.




11. Remove the door glass.

CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removal of the glass.
- Avoid impact and damage to the glass.

INSTALLATION
1. Install in the reverse order of removal.

CAUTION: Make sure that glass stay is placed securely in sash.

2. Adjust the front door glass.

Tightening torque:
T1: 7.4 N.m (0.75 kgf-m, 5.5 ft-lb)
T2: 13.7 N.m (1.4 kgf-m, 10.1 ft-lb)
T3: 5.9 N.m (0.60 kgf-m, 4.4 ft-lb)