Front Speed Sensor

Front Vehicle Speed Sensor

REMOVAL
1. Remove the transmission assembly from vehicle.





2. Remove the rear vehicle speed sensor.

NOTE: Secure the harness of the rear vehicle speed sensor to the transmission proper using wire etc.





3. Remove the extension case.





4. Remove the intermediate case.
5. Remove the center differential carrier.
6. Lay along the transmission case, and then remove the oil pan.
7. Remove the old gasket on the oil pan and transmission case completely.





8. Disconnect the front vehicle speed sensor connector.





9. Remove the front vehicle speed sensor securing bolt.
10. Remove the front vehicle speed sensor through the hole of the AT transmission main case.

INSTALLATION





1. Install the front vehicle speed sensor.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.2 ft. lbs.)
2. Connect the front vehicle speed sensor connector.





3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
4. Install the oil pan by equally tightening the bolts.
Tightening torque: 5 Nm (0.5 kgf-cm, 3.7 ft. lbs.)
5. Install the center differential carrier.





6. Install the intermediate case.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)





7. Install the extension case.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)





8. Install the rear vehicle speed sensor.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.2 ft. lbs.)
9. Install the transmission assembly into the vehicle.
10. Pour ATF from the oil charge pipe.
11. Check the level and leaks of the ATF.