Shifter A/T: Service Precautions

CAUTION
^ Wear work clothing, including a cap, protective goggles, and protective shoes during operation.
^ Remove contamination including dirt and corrosion before removal, installation or disassembly.
^ Keep the disassembled parts in order and protect them from dust and dirt.
^ Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.
^ Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease etc. with that of another grade or from other manufacturers.
^ Be sure to tighten fasteners including bolts and nuts to the specified torque.
^ Place shop jacks or rigid racks at the specified points.
^ Apply grease onto sliding or revolution surfaces before installation.
^ Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.
^ Before securing a part in a vice, place cushioning material such as wood blocks, aluminum plate, or cloth between the part and vice.
^ Before disconnecting electrical connectors, be sure to disconnect the ground cable from battery.