Shift Cable: Adjustments

ADJUSTMENT
1. Shift the select lever to N range.
2. Remove the rear exhaust pipe and muffler.





3. Remove the heat shield cover.





4. Loosen the adjusting nuts on both sides.





5. Turn the adjusting nut B until it lightly touches the connector.





6. Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 Nm (0.76 kgf-cm, 5.5 ft. lbs.)
7. After the completion of adjustment, confirm that the select lever operates normally at all ranges.
8. Install in the reverse order of removal.