Rear Vehicle Speed Sensor

Rear Vehicle Speed Sensor

REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the intercooler. (Turbo model)
4. Remove the air intake chamber. (Non-turbo model)
5. Disconnect the following connectors.
^ Turbo model





1. Transmission harness connectors





2. Front oxygen (A/F) sensor





^ Non-turbo model
6. Remove the transmission harness connector and front oxygen (A/F) sensor connector from the stay.
7. Lift-up the vehicle.
8. Clean the transmission exterior.
9. Drain ATF completely.
10. Remove the center exhaust pipe, rear exhaust pipe and muffler. (Turbo model)
11. Remove the rear exhaust pipe and muffler. (Non-turbo model)
12. Remove the heat shield cover.
13. Remove the propeller shaft.
14. Place the transmission jack under transmission.

NOTE: Make sure that the support plate of transmission jack does not touch the crossmember.





15. Remove the transmission rear crossmember bolt.
16. Lower the transmission jack.

NOTE: Do not separate the transmission jack and transmission.

17. Remove the oil charge pipe.
18. Remove the ATF cooler inlet and outlet pipes.

NOTE: When removing the outlet pipe, be careful not to lose the ball and spring used with retaining screw.





19. Disconnect the connector from turbine speed sensor 1.





20. Remove the rear vehicle speed sensor.
21. Remove the oil pan.





22. Disconnect the control valve connector and front vehicle speed sensor connector.





23. Remove the control valve body.





24. Remove the bolt securing harness of transmission main case.
25. Remove the harness assembly.

INSTALLATION





1. Pass the harness assembly through the hole in transmission case.





2. Install the securing bolt of transmission main case.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.2 ft. lbs.)





3. Install the control valve body.
Tightening torque: 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)

NOTE: Be careful not to catch harness in.





4. Connect the control valve connector and front vehicle speed sensor connector.





5. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
6. Install the oil pan by equally tightening the bolts.
Tightening torque: 5 Nm (0.5 kgf-cm, 3.7 ft. lbs.)
7. Install the rear vehicle speed sensor and turbine speed sensor 1, and then fasten the harness.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.2 ft. lbs.)
8. Install a new aluminum washer and oil cooler pipe.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
9. Install the oil charge pipe.
10. Install the transmission rear crossmember bolt.
Tightening torque: 70 Nm (7.1 kgf-cm, 51.6 ft. lbs.)
11. Install the propeller shaft.
12. Install the heat shield cover.
13. Install the center exhaust pipe, rear exhaust pipes and muffler. (Turbo model)
14. Install the rear exhaust pipe and muffler. (Nonturbo model)
15. Lower the vehicle.
16. Install the transmission connector to the stay, and then connect the connector.
17. Install the intercooler. (Turbo model)
18. Install the air intake chamber. (Non-turbo model)
19. Pour ATF through the oil charge pipe.
20. Check the level and leaks of ATF.
21. Execute the learning control promotion.