Airbag Control Module

Airbag Control Module

REMOVAL

CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed or if water damage is suspected, replace the airbag control module with a new one.
- Do not drop the airbag control module.
- After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the console front panel and console side garnish.




4. Remove the screws and pull out the audio unit assembly to disconnect the connector for removal.
5. Disconnect the connector from airbag control module.




6. Remove the bolts and remove airbag control module.

INSTALLATION

CAUTION:
- Do not reuse the bolt and nut.
- Always use new bolts and nuts for them.
- Be sure to put the water protection cover over the connector.

Install in the reverse order of removal.

Tightening torque: 25 N.m (2.5 kgf-m, 18.1 ft-lb)