Rear Door Latch: Service and Repair

Rear Door Latch & Door Lock Actuator Assembly

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear door trim.
3. Remove the cable from rear inner remote.
4. Remove the sealing cover.
5. Remove the rear door glass.
6. Remove the rear sash.
7. Take out the cable from cable clamp of outer handle.




8. Remove the three screws.
9. Disconnect the connectors, and then remove the rear door latch & door lock actuator assembly.

INSTALLATION
Install in the reverse order of removal.

NOTE: Make sure the lock works correctly after installation.