With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
1. ECM
1. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the "Engine Diagnosis" display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait 3 seconds before starting the engine.
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
2. BODY INTEGRATED UNIT
1. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Integ. unit mode} and press the [YES] key.
3. Press the [YES] key after the {Integ. unit mode} is displayed.
4. On the "Integ. unit mode failure diag" display screen, select the {Clear Memory} and press the [YES] key.
5. When the "Done" are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.