Valve Clearance: Testing and Inspection

INSPECTION
Inspection and adjustment of valve clearance should be performed while engine is cold.
1. Lift-up the vehicle.
2. Remove the under cover.
3. Lower the vehicle.
4. Remove the collector cover.





5. Disconnect the ground cable from battery.
6. Remove the air intake duct.
7. Remove a bolt which secures timing belt cover (RH).
8. Loosen the remaining bolts which secure timing belt cover (RH), then remove the timing belt cover.
9. When inspecting #1 and #3 cylinders:
1 Remove the air cleaner case.
2 Disconnect the connector from ignition coil.
3 Remove the ignition coil.
4 Place a suitable container under the vehicle.
5 Disconnect the PCV hose from rocker cover (RH).
6 Remove the bolts, then remove the rocker cover (RH).
10. When inspecting #2 and #4 cylinders:
1 Disconnect the battery cable, and then remove the battery and battery carrier.
2 Disconnect the connector from ignition coil.
3 Remove the ignition coil.
4 Place a suitable container under the vehicle.
5 Disconnect the PCV hose from rocker cover (LH).
6 Remove the bolts, then remove the rocker cover (LH).





11. Turn the crank pulley clockwise until arrow mark on the cam sprocket is set to position shown in the figure.

NOTE: Turn the crankshaft using a socket wrench.

12. Measure the #1 cylinder intake valve and #3 cylinder exhaust valve clearance by using thickness gauge (A).

NOTE:
^ Insert the thickness gauge in as horizontal a direction as possible with respect to the valve lifter.
^ Measure the exhaust valve clearances while lifting-up the vehicle.

Valve clearance
Intake: 0.20[+0.04/-0.06] mm (0.0079[+0.0016/-0.0024] inch)
Exhaust: 0.35 ± 0.05 mm (0.0138 ± 0.0020 inch)





^ If the measured value is not within specification take notes of the value in order to adjust the valve clearance later on.
13. If necessary, adjust the valve clearance.
14. Further turn the crank pulley clockwise and then measure the valve clearances again.





1 Set the arrow mark on cam sprocket to the position shown in the figure, and measure the #2 cylinder exhaust valve and #3 cylinder intake valve clearances.





2 Set the arrow mark on cam sprocket to the position shown in the figure, and measure the #2 cylinder intake valve and #4 cylinder exhaust valve clearances.





3 Set the arrow mark on cam sprocket to the position shown in the figure, and measure the #1 cylinder exhaust valve and #4 cylinder intake valve clearances.
15. After inspection, install the related parts in the reverse order of removal.