Clockspring Assembly / Spiral Cable: Service and Repair

Roll Connector

REMOVAL
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery, and wait for at least 20 seconds before starting work.
3. Remove the driver's airbag module.
4. Remove the steering wheel.
5. Remove the steering column cover.




6. Remove the screws, and then remove the roll connector.

INSTALLATION
1. Install in the reverse order of removal.
2. Before installing the steering wheel, be sure the direction of roll connector is adjusted with steering.

ADJUSTMENT
1. Check that the front wheels are positioned in straight ahead direction.
2. Turn the roll connector pin (A) clockwise until it stops.




3. Turn the roll connector pin (A) counterclockwise approx. 3.25 turns until "triangle" marks are aligned.