Removal and Replacement

FRONT BUMPER

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the front grille.
3. Remove the nine clips on the upper part of bumper.

4. Turn over the mud guard, and then remove the clips (A) and (B), which secure the front bumper to fender.

5. Remove the two clips (A), turn over the mud guard, and then remove the clip (B). (Conduct the same procedure on the right side.)

6. Remove the four clips in the center part of bumper.

7. Remove the fog light.
8. Remove the bumper from body.
9. Remove the energy absorber foam from front bumper beam.

10. Loosen the bolt and nut, and then remove the bumper beam from body.

INSTALLATION

1. Install in the reverse order of removal.
2. Secure the slider (A) to guide plate (B).

Tightening torque:
Refer to COMPONENT in General Description.
BUMPER, COMPONENT, General Description.>