With Manufacturer's Scan Tool

Subaru Select Monitor
OPERATION

CLEAR MEMORY MODE
1. On the "Main Menu" display screen, select the {2. Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Transmission Control System} and press the [YES] key.
3. Press the [YES] key after the information of transmission type is displayed.
4. On the "Transmission Diagnosis" display screen, select the {Clear Memory} and press the [YES] key.

NOTE: DTC and memory of self-learning control are cleared if {Clear Memory 2} is selected. If it is selected, perform the promotion work of self learning control.

1. Set select lever to "P" range and apply parking brake, then lift up the vehicle.
2. Connect Subaru Select Monitor to vehicle and turn on the switch.
3. Select "Clear Memory - 2" on the SUBARU Select Monitor.
4. Using Subaru Select Monitor, check that the DTC is not output.
5. Using Subaru Select Monitor, warm up the engine until the ATF temperature becomes within 60 - 90°C (140 - 194°F).
6. Set the switches for headlights, air conditioner, rear defogger, etc. to OFF.
7. Turn the ignition switch OFF and then wait for more than 30 seconds.
8. Push shift lock select button, and shift the select lever to the "R" range.
9. If the message "communication impossible" is displayed on SUBARU Select Monitor, depress the brake pedal deeply with left foot until the learning promotion task is completed, and then turn the ignition switch to ON.
10. Check that SUBARU Select Monitor is operating properly now.
11. Set the select lever to "P" range, and then wait for more than three seconds.
12. Set the select lever to "R" range, and then wait for more than three seconds.
13. Set the select lever to "N" range, and then wait for more than three seconds.
14. Set the select lever to "D" range, and then wait for more than three seconds.
15. Set the select lever to "N" range, and then wait for more than three seconds.
16. Slowly depress the accelerator pedal to the fully open position.
17. Slowly release the accelerator pedal to until it reaches to the fully closed position.
18. Start and idle the engine.
19. Set the select lever to "D" range.
20. Learning promotion task starts. AT OIL TEMP warning light in the combination meter blinks at 2 Hz. If ATF temperature does not blink, turn the ignition switch OFF and repeat the procedure from step 4).
Learning promotion task is completed when blinking of AT OIL TEMP warning light in the combination meter changes from 2 Hz to 0.5 Hz.

NOTE: Repeat the procedure from step 4 if blinking of AFT temperature warning light changes from 2 Hz to4 Hz.

21. Set the select lever to "N" range, and turn the ignition switch to OFF.
5. When the "Done" is shown on display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.