Transfer Duty Solenoid and Valve Body
Transfer Duty Solenoid and Valve BodyREMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air cleaner case. (2.5 L model)
4. Remove air intake chamber. (3.0 L model)
5. Remove the pitching stopper.
6. Remove the front exhaust pipe with center exhaust pipe.
7. Remove the rear exhaust pipe and muffler.
8. Raise the vehicle and drain the ATF.
9. Remove the heat shield cover.
10. Remove the propeller shaft.
11. Remove the transmission rear crossmember.
1. Support the transmission using a transmission jack and raise slightly.
2. Remove the bolts and nuts as shown in the figure.
12. Remove the rear vehicle speed sensor.
13. Remove the select cable nut.
14. Move the gear select cable so that extension bolts can be removed.
15. Remove the bolts.
16. Remove the extension case.
NOTE: Use a container to catch oil flowing from extension.
17. Disconnect the transfer duty solenoid connector.
18. Remove the transfer duty solenoid and transfer valve body.
INSTALLATION
1. Install the transfer duty solenoid and transfer valve body.
1. Install the transfer duty solenoid and transfer valve body.
Tightening torque: T: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
2. Connect the transfer duty solenoid connector.
2. Install a new gasket and the extension case to transmission case.
1. Tighten eleven bolts.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Adjust the select cable.
3. Install the rear vehicle speed sensor.
Tightening torque: T: 7 Nm (0. 7 kgf-m, 5.1 ft. lbs.)
4. Install the transmission rear crossmember.
1. Tighten the bolts.
Tightening torque:
T1: 35 Nm (3.6 kgf-m, 26 ft. lbs.)
T2: 70 Nm (7.1 kgf-m, 51 ft. lbs.)
2. Remove the transmission jack.
5. Install the propeller shaft.
6. Install the front, center rear exhaust pipe and muffler.
7. Connect the transmission harness connector.
8. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-m, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-m, 43 ft. lbs.)
9. Install the air cleaner case.
10. Install air intake chamber. (3.0 L model)
11. Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
12. Check the ATF level.