Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE





1. Prepare Subaru Select Monitor kit.
2. Connect diagnosis cable to Subaru Select Monitor.





3. Insert cartridge into Subaru Select Monitor.





4. Connect Subaru Select Monitor to data link connector.
1. Data link connector located in the lower portion of the instrument panel (on the driver's side).
2. Connect diagnosis cable to data link connector.





NOTE: Do not connect scan tools except for Subaru Select Monitor and OBD-II general scan tool.

5. Turn ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6. On the [[Main Menu,> display screen, select the {Each System Check} and press the [YES] key.
7. On the [[System Selection Menu,, display screen, select the {Transmission Control System} and press the [YES] key.
8. Press the [YES] key after displayed the information of transmission type.





9. On the [[Transmission Diagnosis]] display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
10. On the
NOTE:
^ For detailed operation procedure, refer to the SELECT MONITOR OPERATION MANUAL.
^ For detailed concerning diagnostic trouble codes, refer to the DIAGNOSTIC TROUBLE CODE LIST.