Brake Pipe

Brake Pipe

REMOVAL

NOTE: Airbag system wiring harness is routed near the center brake pipe

CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
^ Be careful not to damage airbag system wiring harness when servicing the center brake pipe.
^ When removing the brake pipe, make sure that it is not bent.

INSTALLATION

NOTE: Airbag system wiring harness is routed near the center brake pipe

CAUTION:
^ All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
^ Be careful not to damage airbag system wiring harness when servicing the center brake pipe.
^ When installing the brake pipe, make sure that it is not bent.
^ After installing the brake pipe and hose, bleed the air.
^ After installing the brake hose, make sure that it does not touch the tire or suspension assembly, etc.
Brake pipe tightening torque: 15 Nm (1.5 kgf-cm, 10.8 ft. lbs.)

INSPECTION
Ensure there are no cracks, breakage, or damage on pipes Check joints for fluid leakage. If any cracks, breakage, damage or leakage is found, repair or replace pipe

NOTE: Use a mirror when inspecting low-visible part or back side