> display screen, select the {Each System Check} and press the [YES] key.
7. On the <> display screen, select the {Brake Control System} and press the [YES] key.
8. Press the [YES] key after displayed the information of engine type.
9. On the <

10. On the <> display screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)} and press the [YES] key.

NOTE:
^ For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
^ For detailed concerning diagnostic trouble codes, refer to the DIAGNOSTIC TROUBLE CODE LIST.
^ A maximum of 3 trouble codes are displayed in order of occurrence.

*a* refers to the troubles in order of occurrence (Latest, Old, Older).

READ CURRENT DATA
1. On the <

> display screen, select {Each System Check} and press the <> key.
2. On the <> key.
3. Press the <> key after the VDC type is displayed.
4. On the <> display screen, select {Current Data Display & Save} and press the <> key.
5. On the <> display screen, select {Data Display} and press the <> key.
6. Using the scroll key, move the display screen up or down until the desired data is shown.

^ A list of the support data is shown in the following table.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

CLEAR MEMORY MODE
1. On the <

> key.
2. On the <> display screen, select {Brake System} and press the <> key.
3. Press the < 4. On the <> display screen, select {Clear Memory} and press the <> key.
5. When 'Done' and turn ignition switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

FUNCTION CHECK