Speedometer Gear, M/T: Service and Repair

REMOVAL
1. Remove the manual transmission assembly from vehicle.
2. Remove back-up light switch and neutral position switch.
3. Remove transfer case with extension case assembly.
4. Remove transmission case.
5. Remove vehicle speed sensor.





6. Remove outer snap ring and pull out speedometer driven gear. Next, remove oil seal, speedometer shaft and washer.

INSTALLATION
1. Install washer and speedometer shaft, and press fit oil seal with ST.

NOTE: Use new oil seal, if it has been removed.

ST 899824100 or 499827000 PRESS
2. Install vehicle speed sensor.





3. Install speedometer driven gear and snap ring.

NOTE: Use new snap ring, if it has been removed.

4. Install transmission case.
5. Install transfer case with extension case assembly.
6. Install back-up light switch and neutral position switch.
7. Install the manual transmission assembly to vehicle.