With Manufacturer's Scan Tool

SUBARU SELECT MONITOR (NORMAL MODE)
1. On the [Main Menu> display screen, select the {2. Each System Check} and press the [YES] key.
2. On the [System Selection Menu> display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the [Engine Diagnosis> display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' and 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SUBARU SELECT MONITOR (OBD MODE)
1. On the [Main Menu> display screen, select the {2. Each System Check} and press the [YES] key.
2. On the [System Selection Menu> display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the [Engine Diagnosis> display screen, select the {OBD System} and press the [YES] key.
5. On the [OBD Menu> display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7. Turn Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.