Removal and Installation

REMOVAL
1. MT MODEL
1. Pull up parking brake lever and block tires.
2. Disconnect ground cable from battery.
3. Remove steering column.
4. Disconnect connectors from stop light and clutch switches.
5. Remove snap pins which secure lever to push rod and operating rod.





6. Remove clevis pins which secure lever to push rod and operating rod.





7. Remove nut which secures clutch master cylinder.
8. Remove bolts and nuts which secure brake and clutch pedals, and remove pedal assembly.

2. AT MODEL
1. Pull up parking brake lever.
2. Disconnect ground cable from battery.
3. Remove instrument panel lower cover from instrument panel.
4. Remove clevis pin which secures brake pedal to brake booster operating rod. Also disconnect stop light switch connector.





5. Remove two bolts and four nuts which secure brake pedal to pedal.

INSTALLATION
1. Install in the reverse order of removal.

CAUTION:
^ If cable clamp is damaged, replace it with a new one.
^ Never fail to cover outer cable end with boot.
^ Be careful not to kink accelerator cable.
^ Always use new clevis pins.

2. Adjustment of clutch pedal
3. Inspect after pedal installation