With Subaru Select Monitor

3. CLEAR MEMORY MODE
1. On the Main Menus display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the Transmission Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' end 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.