Subaru Select Monitor (Normal Mode)

SUBARU SELECT MONITOR (NORMAL MODE)

1. On the [[Main Menu]] display screen, select the {2. Each System Check} and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the [[Engine Diagnosis]] display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' and 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.