Backup Lamp Switch: Service and Repair

A: REMOVAL
1. Disconnect connector battery ground terminal.





2. Disconnect connector back-up light switch and neutral position switch.
3. Lift-up the vehicle.





4. Remove back-up light switch and neutral position switch with harness.

B: INSTALLATION





1. Install back-up light switch and neutral position switch with harness.
Tightening torque: 24.5 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Disconnect connector of back-up light switch and neutral position switch.
3. Connect battery ground terminal.