As A Detached ELR With Pretensioner

WARNING: Do not discard undeployed ELR with pretensioner since it can cause serious personal injury when accidentally deployed.

CAUTION:
- Deployment of ELR with pretensioner should be done on a flat place free from any possible danger. Avoid outdoors during rain or windy weather.
- Since deploying ELR with pretensioner causes a high explosive noise, make sure to warn people around you and do not allow anyone within a 5 m (16 ft) radius of the disposal site.
- Some smoke will be emitted from deployment of ELR with pretensioner. Therefore, do not activate near fire or smoke sensor.
- Wear gloves and goggles during this operation and wash hands afterwards.

AS A DETACHED ELR WITH PRETENSIONER
1. Turn ignition switch off.
2. Disconnect ground cable from battery, and wait for at least 20 seconds before starting work.
3. Remove ELR with pretensioner.




4. Cut the webbing of ELR with pretensioner.

NOTE: Cut webbing as close possible to ELR.




5. Short deployment tool alligator clip to terminal.

Deployment tool: (PN. 98299PA030)

CAUTION: Deployment tool should be kept shorted until just before deployment of ELR with pretensioner.

6. Connect deployment tool connector (1D) and ELR with pretensioner "YELLOW" connector.
7. Bundle three wire automotive harnesses [each with a sectional area of 1.25 sq. mm (0.00194 sq. in) or more] and bind them two folds around ELR with pretensioner bracket.




8. Install ELR with pretensioner on disk wheel with tire attached.




9. Pile three tires without disk wheel upon the tire installed with ELR with pretensioner. Pile upon this an additional tire with disk wheel. Fasten this pile tight with rope.




10. Extend deployment tool to the limit. Secure area. Then connect deployment tool alligator clip to battery minus terminal and the other terminal to battery plus terminal.
11. After deployment, ELR with pretensioner is extremely hot. Leave it unattended for 40 minutes.

CAUTION: Do not apply water to cool it down.




12. Remove deployed ELR with pretensioner. Wrap it in an airtight vinyl bag and discard. Do not attempt to disassemble or incinerate ELR with pretensioner.