Main Harness

REMOVAL AND INSTALLATION

1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.




4. Disconnect airbag connector (AB3) and (AB8) below steering column.

CAUTION: Do not reconnect airbag connector at steering column until main harness are securely re-installed.

5. Remove instrument panel.




6. Disconnect connector from airbag control module.




7. Disconnect body harness connector (B31) from airbag connector (AB1) located in front pillar lower (driver side).




8. Disconnect front sub sensor connector (blue) from airbag main harness.




9. Detach clips from steering support beam and remove main harness.
10. Installation is in the reverse order of removal.