Disassembly and Assembly

CAUTION:
- Do not touch the printed circuit elements with your bare hand. Use a suitable tool.
- Do not touch the indicator plate and pointer with your bare hand.

1. Disengage pawls (F) and then remove back panel (A) from case (B).




2. Disengage pawls (G) and then remove lens mask (E), reflector (D) and window plate (C) from case (B).
3. Pry up pawl (A) at portion (B) of printed circuit (C) using radioman's pliers. Push speedometer assembly (D) and tachometer assembly (E) out of hole (F) with a punch.




4. Pry up the pawl in the center of printed circuit (C) and remove the printed circuit board from case (G).
5. Assembly is in the reverse order of disassembly.