With Manufacturer's Scan Tool

SUBARU SELECT MONITOR (NORMAL MODE)
1. On the [Main Menu] display screen, select the {2. Each System Check} and press the [YES] key.
2. On the [System Selection Menu] display screen, select the {EGI/EMPI} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the [EGI/EMPI Diagnosis] display screen, select the {3. Clear Memory} and press the [YES] key.
5. When the 'Done' and 'Turn Ignition Switch OFF ' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (2200 cc except California spec. vehicles only)
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SUBARU SELECT MONITOR (OBD MODE)
1. On the [Main Menu] display screen, select the {2. Each System Check} and press the [YES] key.
2. On the [System Selection Menu] display screen, select the {EGI/EMPI} and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the [EGI/EMPI Diagnosis] display screen, select the {7. OBD System} and press the [YES] key.
5. On the [OBD Menu] display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7. Turn Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (2200 cc except California spec. vehicles only)
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.