Air Bag Control Module: Service and Repair

Airbag Control Module

REMOVAL AND INSTALLATION

CAUTION:




- Do not disassemble the airbag control module.




- If the airbag control module is deformed, or if water damage is suspected, replace the airbag control module with a new genuine part.




- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.




1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover. Disconnect airbag connector (AB3) and (AB8) below steering column.

CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.




4. Remove console box.
5. Disconnect connector from airbag control module.
6. Using TORX© BIT T40 (Tamper resistant type), remove two TORX© bolts. Discard the old TORX© bolts.

CAUTION: Use new TORX© bolts during re-assembly.

7. Installation is in the reverse order of removal.