Component Tests and General Diagnostics
SECURITY SYSTEM OPERATION1. Fully open all the door windows.
2. Turn the ignition switch to OFF and remove ignition key from ignition switch.
3. Get out of the vehicle and lock the driver's door using a ignition key.
4. Check that the security indicator light illuminates.
5. When the security indicator light illuminates, wait for 30 seconds.
After 30 seconds, check that the light starts repeating 0.2 sec. ON and 2.4 sec. OFF sequence.
6. Unlock the driver's door using the inside lock knob and open the door.
Ensure that:
1. The horn sounds and headlights flash intermittently at 0.2 sec. ON and 0.6 sec. OFF intervals, and
2. The engine will not start even if the ignition switch is turned to START.
7. Unlock the driver's door one time using the ignition key.
Ensure the horn and headlights turn off.
8. Close and lock the driver's door without using a ignition key. (Set the inside lock knob to LOCK and then close the door while lifting the outer handle).
Check that the security indicator light illuminates continuously.
9. Within 30 seconds after the above step 8), unlock the rear LH door using the inside lock knob and open the door.
Check that the security indicator light flashes at 0.5 sec. intervals.
10. Close the rear LH door and lock the door using the inside lock knob.
Check that the security indicator light illuminates continuously.
11. Perform the above steps 9) and 10) on the rear RH door and front RH door.
12. Within 30 seconds after above step 11) has been finished, pull the engine hood opener lever and open the engine hood.
Check that the security indicator light flashes at 0.5 sec. intervals.
13. Close the engine hood completely.
Check that the security indicator light illuminates continuously.
14. Within 30 seconds after the above step 13), pull the trunk lid opener lever and open the trunk lid (SEDAN); or unlock the rear gale by operating the driver's door inside lock knob and open the rear gate (WAGON). Check that the security indicator light flashes at 0.5 sec. intervals.
15. Close the trunk lid completely (SEDAN); or close the rear gate and lock by locking the driver's door using a ignition key (WAGON).
Check that the security indicator light illuminates continuously.
16. When the security indicator light illuminates continuously, wait for 30 seconds.
After 30 seconds, check that the light starts repeating 0.2 sec. ON and 2.4 sec. OFF sequence.
17. Unlock the trunk lid (SEDAN) or rear gate (WAGON) using a ignition key and open.
Check that the horn and headlights do not operate.
18. Close the trunk lid (SEDAN) or rear gate (WAGON).
19. Unlock and then lock the driver's door using a ignition key and wait for 30 seconds.
After 30 seconds, check that the light starts repeating 0.2 sec. ON and 2.4 sec. OFF sequence.
20. Only WAGON model; unlock and then lock the rear gate using a ignition key and wait for 30 seconds. After 30 seconds, check that the light starts repeating 0.2 sec. ON and 2.4 sec. OFF sequence.
21. Unlock the front RH door using a ignition key and open the door.
Check that the horn and headlights do not operate. After finishing the above checks, ensure that security system's function is correct.