Assembly

ASSEMBLY
To assemble, reverse above disassembly procedures





Front Bushing
Using ST, press bushing into trailing link. ST 927720000 INSTALLER & REMOVER SET





CAUTION: When installing bushing, turn ST plunger upside down and press it until plunger end surface contacts trailing link end surface.

CAUTION: Install front bushing in the proper direction, as shown in figure.

Rear Bushing





1) Using ST, press bushing into trailing link. ST 927730000 INSTALLER & REMOVER SET

NOTE: If it is difficult to press bushing into trailing link, apply water-diluted TIRE LUBE to the inner surface of ST as a lubricant.

Specified lubricant:
TIRE LUBE: water = 1 : 3





2) Press ST plunger until bushing flange protrudes beyond trailing link. ST 927730000 INSTALLER & REMOVER SET





3) Turn trailing link upside down. Press ST plunger in the direction opposite that outlined in step 2) until bushing is correctly positioned in trailing link. ST 927730000 INSTALLER & REMOVER SET