Air Bag Control Module: Service and Repair
Airbag Control ModuleCAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed, or if water damage is suspected, replace the airbag control module with a new genuine part.
- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.
REMOVAL
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
4. Remove console box.
5. Disconnect 12-pin yellow, 2-pin blue and 2-pin orange connectors from airbag control module.
6. Using TORX© BIT T40 (Tamper resistant type), remove two TORX© bolts.
Discard the old TORX© bolts.
CAUTION: Use new TORX© bolts during re-assembly.
INSTALLATION
Installation is in reverse order of removal procedures.
CAUTION: Be sure to fully secure all airbag system connectors during re-assembly and confirm that all green double lock mechanisms are engaged.