Without Airbag

COMBINATION SWITCH (WITHOUT AIRBAG MODEL)

Refer Combination Switch for removal of combination switch on airbag equipped model.

1. Remove steering wheel.




2. Remove screws which secure upper column cover to lower column cover.
3. Remove screws which secure knee protector and remove knee protector.

CAUTION: When installing knee protector, ensure that harness is not caught by adjacent parts.

4. Disconnect connector from body harness and undo holddown band.




5. Remove screws which secure switch and remove switch.

CAUTION: During installation (with key interlock)
- When routing combination switch harness around steering system, do not place it over key interlock release knob.
- After installing lower column cover, ensure that key interlock release knob is accessible.