Brake Pressure Hold Valve Cable: Adjustments

1. Confirm stopping and starting performance by activating hill-holder on an uphill road of 3� or higher inclination.





CAUTION:
(1) If vehicle does not stop; Tighten adjusting nut of Pressure Hold Valve (PHV) cable.
(2) If vehicle does not start properly;
^ Case A - When hill-holder is released later than engagement of clutch (engine tends to stall): Loosen adjusting nut gradually until smooth starting is enabled.
^ Case B - When hill-holder is released earlier than engagement to clutch (vehicle slips down slightly): Tighten adjusting nut so that hill-holder is released later than engagement of clutch (status in Case A).
Then make adjustment the same as in Case A.





NOTE:
^ Whenever turning adjusting nut, hold inner cable with pliers to prevent it from turning.
^ Replace PHV, return spring of PHV or PHV cable with new one, if they are defective and/or damaged.