Drive Pinion Shaft

1. DRIVE PINION SHAFT





1) Straighten lock nut at staked portion. Remove the lock nut using ST1, ST2 and ST3.

ST1 899884100 HOLDER
ST2 498427100 STOPPER
ST3 899988608 SOCKET WRENCH





2) Withdraw drive pinion from driven shaft.
Remove differential bevel gear sleeve (1), adjusting washer No.1 (2) (25 x 37.5 x t), adjusting washer No.2 (3) (25 x 37.5 x 4) thrust bearing (4) (25 x 37.5 x 3), needle bearing (5) (25 x 30 x 20), drive pinion collar (6), needle bearing (7) (30 x 37 x 23) and thrust bearing (8) (33 x 50 x 3).





3) Remove roller bearing and washer (33 x 50 x 5) using ST and press. ST 498077000 REMOVER

CAUTION: Do not reuse roller bearing.