Installation

INSTALLATION
1) Install strut mount at upper side of strut to body and tighten with nuts.

Tightening torque:
20 ± 6 Nm (2.0 ± 0.6 kg-m, 14.5 ± 4.3 ft-lb)

2) Connect housing to lower side of strut.
3) Position aligning mark on camber adjusting bolt with aligning mark on lower side bracket of strut.

CAUTION:
- While holding head of adjusting bolt, tighten self- locking nut.
- Be sure to use new self-locking nut.

Tightening torque:
152 ± 20 Nm (15.5 ± 2.0 kg-m, 112 ± 14 ft-lb)

4) Install A.B.S. sensor harness to strut. (A.B.S. equipped models.)

Tightening torque:
152 ± 20 Nm (15.5 ± 2.0 kg-m, 112 ± 14 ft-lb)

5) Install brake hose at lower side of strut with clamp.





6) Install union bolts which secure brake caliper to brake hose.

Tightening torque:
18 ± 3 Nm (1.8 ± 0.3 kg-m, 13.0 ± 2.2 ft-lb)

CAUTION: Be sure to bleed air from brake system.

7) Install wheels.

NOTE: Check wheel alignment and adjust if necessary.