Installation

INSTALLATION
1) To install, reverse the removal procedure.

NOTE:
- Install bushing (on front crossmember side) while aligning it with paint mark on stabilizer.
- Ensure that bushing and stabilizer have the same identification colors when installing.

2) Always tighten rubber bushing location when wheels are in full contact with the ground and vehicle is at curb weight condition.

Tightening torque:
Jack-up plate to crossmember:
18 ± 5 Nm (1.8 ± 0.5 kg-m, 13.0 ± 3.6 ft-lb)
Stabilizer link to front transverse link:
29 ± 5 Nm (3.0 ± 0.5 kg-m, 21.7 ± 3.6 ft-lb)
Stabilizer to crossmember:
25 ± 4 Nm (2.5 ± 0.4 kg-m, 18.1 ± 2.9 ft-lb)