Assembly

ASSEMBLY





1) Using ST, press bushing into place.

CAUTION: Select ST according to the type of bushings used.





NOTE;
- Use the same ST as that used during disassembly.
- If it is difficult to press bushing into trailing link, apply water-diluted TIRE LUBE to the inner surface of ST as a lubricant.

Specified lubricant:
TIRE LUBE: water = 1 : 3

NOTE: Pay attention to the direction of bushing "D" as shown in figure.





2) Press ST plunger until bushing flange protrudes beyond lateral link.

NOTE: Use the same ST as that used during disassembly.





3) Turn lateral link upside down. Press ST plunger in the opposite direction that outlined in step 2) until bushing is correctly positioned in trailing link.

NOTE: Use the same ST as that used during disassembly.